Files
sirjassam 4220b0055f Add PrintaLot PETG profiles for Bambu Lab printers (#17029)
* Add PrintaLot PETG profiles for Bambu Lab printers

* Remove redundant PETG defaults after independent review

* Declare PrintaLot PETG's own values on its base

The type, 255 °C and the 17 mm³/s limit are PrintaLot's values, not the
library's PETG defaults, so they should not change if fdm_filament_pet
does. filament_type is also part of the filament_id.

* Drop PrintaLot PETG values Bambu Lab printers never read

- The multitool ramming values: only the Type 2 prime tower reads them,
  and Bambu Lab printers always use Type 1.
- volumetric_speed_coefficients: only read with adaptive volumetric
  speed, which is off.
- filament_retract_length_nc outside the H2C: only the H2C's
  change-filament G-code reads it.
- retraction_distances_when_ec where long retraction on extruder change
  is off.
- filament_preheat_temperature_delta outside the H2C: only used on
  printers with several nozzles per extruder.
- filament_flush_temp_fast 0 and filament_extruder_variant
  "Direct Drive Standard": both are the defaults.

* Move values shared by the PrintaLot PETG presets to the base

The 17 mm³/s limit and slow_down_min_speed are the same in every preset
except the 0.2 nozzles (1 mm³/s) and the A2L 0.2 nozzle (40 mm/s), and
most presets write the same placeholder filament start and end G-code.
Presets with other values keep their own.

* bump OrcaFilamentLibrary.json

---------

Co-authored-by: Ian Bassi <ian.bassi@outlook.com>
Co-authored-by: Rodrigo Faselli <162915171+RF47@users.noreply.github.com>
(cherry picked from commit 7374b734d3)
2026-11-07 02:14:51 +08:00
..