From feb889674be2b4b162916437668ab436d851aa8f Mon Sep 17 00:00:00 2001 From: SoftFever Date: Mon, 20 Oct 2025 13:46:13 +0000 Subject: [PATCH] Updated Wiki content --- print_settings/quality/quality_settings_wall_and_surfaces.md | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/print_settings/quality/quality_settings_wall_and_surfaces.md b/print_settings/quality/quality_settings_wall_and_surfaces.md index 5674f41..fce72ef 100644 --- a/print_settings/quality/quality_settings_wall_and_surfaces.md +++ b/print_settings/quality/quality_settings_wall_and_surfaces.md @@ -60,7 +60,9 @@ Set this to any option other than Auto will force the wall direction regardless ## Surface flow ratio This factor affects the amount of material for [top or bottom solid infill](strength_settings_top_bottom_shells). You can decrease it slightly to have smooth surface finish. -The actual top surface flow used is calculated by multiplying this value with the filament flow ratio, and if set, the object's flow ratio. +The actual top or bottom surface flow used is calculated by multiplying this value by the filament flow ratio, and if set, the object's flow ratio. + +Other flow ratios, such as ratios for the first layer (does not affect brims and skirts), outer and inner walls, overhang perimeters, sparse infill, internal solid infill, gap fill, support, and support interfaces, can also be adjusted after enabling the "Set other flow ratios" option. > [!TIP] > Before using a value other than 1, it is recommended to [calibrate the flow ratio](flow-rate-calib) to ensure that the flow ratio is set correctly for your printer and filament.