Updated Wiki content

Calibration.md

@@ -176,7 +176,9 @@ Ussualy the recommended values modes are ``MZV`` or ``EI`` for Delta printers.
 1. Pre-requisites:
    1. In OrcaSlicer, set:
       1. Acceleration high enough to trigger ringing (e.g., 2000 mm/s²).
-      2. Speed high enough to trigger ringing (e.g., 100 mm/s).
+      2. Speed high enough to trigger ringing (e.g., 200 mm/s).
+      > [!NOTE]
+      > These settings depend on your printer's motion ability and the filament's max volumetric speed. If you can't reach speeds that cause ringing, try increasing the filament's max volumetric speed (avoid materials below 10 mm³/s).
       3. Jerk [Klipper Square Corner Velocity](https://www.klipper3d.org/Kinematics.html?h=square+corner+velocity#look-ahead) to 5 or a high value (e.g., 20).
    2. In printer settigs:
       1. Set the Shaper Type to ``MZV`` or ``EI``.
@@ -223,8 +225,10 @@ ZV Input Shaping introduces an anti-vibration signal into the stepper motion for
 1. Pre-requisites:
    1. In OrcaSlicer, set:
       1. Acceleration high enough to trigger ringing (e.g., 2000 mm/s²).
-      2. Speed high enough to trigger ringing (e.g., 100 mm/s).
+      2. Speed high enough to trigger ringing (e.g., 200 mm/s).
-      3. Jerk
+      > [!NOTE]
+      > These settings depend on your printer's motion ability and the filament's max volumetric speed. If you can't reach speeds that cause ringing, try increasing the filament's max volumetric speed (avoid materials below 10 mm³/s).
+      4. Jerk
          1. If using [Classic Jerk](https://marlinfw.org/docs/configuration/configuration.html#jerk-) use a high value (e.g., 20).
          2. If using [Junction Deviation](https://marlinfw.org/docs/features/junction_deviation.html) (new Marlin default mode) this test will use 0.25 (high enough to most printers).
    2. Use an opaque, high-gloss filament to make the ringing more visible.