Claude 829124982d Design tab: one rule for mouse, Enter and Esc; honest status messages ...

Keyboard and mouse
- Esc drops what is pending (picks, a dimension's first point, an edit-op or transform) and
  never applies it; Enter applies a ready edit-op/transform, ends a polyline/spline chain,
  ends an armed tool, and confirms a feature card exactly when its ✓ is enabled.
- Right-click only abandons the gesture in progress; with nothing pending it opens the offer
  in every tool (Trim, edit-ops, transforms, Dimension, Constrain, TransformArt, move gizmo).
  Clicking empty space no longer commits. The offer needs no timing, only a still press.
- Delete removes only an explicit selection. Undo/redo inside a sketch go through the same
  route as the buttons (whole shapes, with redo); Edit > Undo follows the shown tab.
- The canvas no longer handles Delete/Esc/Ctrl+Z itself (Backspace in a value field deleted
  the geometry it measured); F is in the panel's key map.
- Value fields: a refused value keeps the field open with the reason; click outside and Tab
  commit; an untouched field commits the exact value; any decimal separator is accepted;
  lengths are always mm; validation is the same for every editor.
- Snapping: the marker shows only where the click will actually snap; pick tolerances are
  one set of pixel budgets (Constrain picks within reach; no mm floor on labels).

Messages and consistency
- set_status(kind, text) gives every status line its own colour and glyph; kernel errors are
  translated into sentences and formatted, not concatenated; sketch refusals go to the status
  line instead of the per-frame HUD that erased them.
- Hints describe the gestures that now work; Dimension shows its second step; Constrain uses
  the sketch palette (red means conflict only); the straight slot's value is its width.
- Hole/Thread/Project keep the user's pick or refuse up front; circular pattern opens with its
  own preview; thread fields use the nominal diameter and the ISO internal depth.

Integration
- MCP loads the project's recipe before touching the document, refuses to mutate it while the
  tab is busy, never runs a request that already timed out, only replaces a socket at its
  path, caps line length and removes the socket at exit; not started in the G-code viewer.
- Hiding a feature keeps later body references on their bodies; a design keeps its modeling
  origin across printer changes.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01QK4VgguuCAk2hZLWgcjJb9

2026-09-30 08:34:25 +00:00

..

CAD

Design tab: one rule for mouse, Enter and Esc; honest status messages

2026-09-30 08:34:25 +00:00

HLSD

perf: load presets in parallel, cutting preset load time by over 60% (#15943)

2026-09-29 18:13:44 -03:00