mirror of
https://github.com/OrcaSlicer/OrcaSlicer.git
synced 2026-05-14 17:12:07 +00:00
16727644bb
Reduce the size of current and new JSONs by standardising them with 1 tab indentation instead of 4 spaces. This effectively reduces the size by almost 20 MB. | Current | New | |---|---| | 85.2 Mib | 67 Mib | Used [JQ](https://jqlang.org/) `--tab` to automatically format every current JSON. > [!NOTE] > Some profiles had the arrays on the same line, but those created by Orca were in the standard format (each object below the previous one). In some cases, this increases the number of tabs due to the new lines, but the increase is negligible, and this way both the base profiles and those created by Orca maintain the same style.
25 lines
956 B
JSON
25 lines
956 B
JSON
{
|
|
"type": "filament",
|
|
"name": "Generic PLA Silk @base",
|
|
"inherits": "fdm_filament_pla",
|
|
"from": "system",
|
|
"filament_id": "GFL96",
|
|
"instantiation": "false",
|
|
"description": "To make the prints get higher gloss, please dry the filament before use, and set the outer wall speed to be 40 to 60 mm/s when slicing.",
|
|
"filament_flow_ratio": [
|
|
"0.98"
|
|
],
|
|
"supertack_plate_temp": [
|
|
"35"
|
|
],
|
|
"supertack_plate_temp_initial_layer": [
|
|
"35"
|
|
],
|
|
"slow_down_layer_time": [
|
|
"8"
|
|
],
|
|
"filament_start_gcode": [
|
|
"; filament start gcode\n{if (bed_temperature[current_extruder] >45)||(bed_temperature_initial_layer[current_extruder] >45)}M106 P3 S255\n{elsif(bed_temperature[current_extruder] >35)||(bed_temperature_initial_layer[current_extruder] >35)}M106 P3 S180\n{endif};Prevent PLA from jamming\n\n{if activate_air_filtration[current_extruder] && support_air_filtration}\nM106 P3 S{during_print_exhaust_fan_speed_num[current_extruder]} \n{endif}"
|
|
]
|
|
}
|