{
	"type": "filament",
	"name": "BETA PLA Basic @base",
	"inherits": "fdm_filament_pla",
	"from": "system",
	"filament_id": "OFuvOt0r",
	"instantiation": "false",
	"filament_cost": [
		"24.99"
	],
	"filament_density": [
		"1.26"
	],
	"filament_flow_ratio": [
		"0.98"
	],
	"filament_max_volumetric_speed": [
		"21"
	],
	"filament_vendor": [
		"BETA"
	],
	"filament_scarf_seam_type": [
		"none"
	],
	"filament_scarf_height": [
		"10%"
	],
	"filament_scarf_gap": [
		"0%"
	],
	"filament_scarf_length": [
		"10"
	],
	"filament_change_length": [
		"5"
	],
	"filament_prime_volume": [
		"30"
	],
	"impact_strength_z": [
		"13.8"
	],
	"compatible_printers": [],
	"filament_start_gcode": [
		"; filament start gcode\n{if  (bed_temperature[current_extruder] >55)||(bed_temperature_initial_layer[current_extruder] >55)}M106 P3 S200\n{elsif(bed_temperature[current_extruder] >50)||(bed_temperature_initial_layer[current_extruder] >50)}M106 P3 S150\n{elsif(bed_temperature[current_extruder] >45)||(bed_temperature_initial_layer[current_extruder] >45)}M106 P3 S50\n{endif}\n\n{if activate_air_filtration[current_extruder] && support_air_filtration}\nM106 P3 S{during_print_exhaust_fan_speed_num[current_extruder]} \n{endif}"
	],
	"close_additional_fan_first_x_layers": [
		"3"
	],
	"retraction_distances_when_ec": [
		"0"
	],
	"slow_down_min_speed": [
		"20"
	],
	"filament_end_gcode": [
		"; filament end gcode \n\n"
	],
	"volumetric_speed_coefficients": [
		"0 0 0 0 0 0"
	],
	"filament_adhesiveness_category": [
		"100"
	],
	"filament_dev_chamber_drying_bed_temperature": [
		"70"
	],
	"filament_dev_ams_drying_time": [
		"12",
		"12",
		"12",
		"12"
	],
	"filament_dev_ams_drying_ams_limitations": [
		"1",
		"0"
	],
	"filament_dev_ams_drying_heat_distortion_temperature": [
		"45"
	],
	"filament_dev_drying_cooling_temperature": [
		"45"
	],
	"filament_dev_ams_drying_temperature": [
		"45",
		"45",
		"45",
		"45"
	],
	"filament_dev_drying_softening_temperature": [
		"50"
	]
}