{
    "type": "filament",
    "name": "Bambu PLA Basic @BBL H2D",
    "inherits": "Bambu PLA Basic @base",
    "from": "system",
    "setting_id": "GFSA00_12",
    "instantiation": "true",
    "additional_cooling_fan_speed": [
        "75"
    ],
    "fan_max_speed": [
        "80"
    ],
    "fan_min_speed": [
        "60"
    ],
    "filament_deretraction_speed": [
        "nil",
        "nil"
    ],
    "filament_extruder_variant": [
        "Direct Drive Standard",
        "Direct Drive High Flow"
    ],
    "filament_flow_ratio": [
        "0.98",
        "0.98"
    ],
    "filament_long_retractions_when_cut": [
        "nil",
        "nil"
    ],
    "filament_max_volumetric_speed": [
        "21",
        "21"
    ],
    "filament_retract_before_wipe": [
        "nil",
        "nil"
    ],
    "filament_retract_lift_above": [
        "nil",
        "nil"
    ],
    "filament_retract_lift_below": [
        "nil",
        "nil"
    ],
    "filament_retract_restart_extra": [
        "nil",
        "nil"
    ],
    "filament_retract_when_changing_layer": [
        "nil",
        "nil"
    ],
    "filament_retraction_distances_when_cut": [
        "nil",
        "nil"
    ],
    "filament_retraction_length": [
        "nil",
        "nil"
    ],
    "filament_retraction_minimum_travel": [
        "nil",
        "nil"
    ],
    "filament_retraction_speed": [
        "nil",
        "nil"
    ],
    "filament_wipe": [
        "nil",
        "nil"
    ],
    "filament_wipe_distance": [
        "nil",
        "nil"
    ],
    "filament_z_hop": [
        "nil",
        "nil"
    ],
    "filament_z_hop_types": [
        "nil",
        "nil"
    ],
    "nozzle_temperature": [
        "220",
        "220"
    ],
    "nozzle_temperature_initial_layer": [
        "220",
        "220"
    ],
    "compatible_printers": [
        "Bambu Lab H2D 0.4 nozzle",
        "Bambu Lab H2D 0.6 nozzle"
    ],
    "filament_start_gcode": [
        "; filament start gcode\nM145 P0 ; set airduct mode to cooling mode\nM142 P1 R35 S40 U0.3 V0.5 ; set chamber autocooling"
    ],
    "filament_end_gcode": [
        "; filament end gcode \n"
    ]
}