{
	"type": "machine",
	"name": "fdm_machine_common",
	"from": "system",
	"instantiation": "false",
	"printer_technology": "FFF",
	"gcode_flavor": "marlin",
	"silent_mode": "0",
	"machine_max_acceleration_e": [
		"5000"
	],
	"machine_max_acceleration_extruding": [
		"7000"
	],
	"machine_max_acceleration_retracting": [
		"7000"
	],
	"machine_max_acceleration_travel": [
		"7000"
	],
	"machine_max_acceleration_x": [
		"7000"
	],
	"machine_max_acceleration_y": [
		"7000"
	],
	"machine_max_acceleration_z": [
		"300"
	],
	"machine_max_speed_e": [
		"60"
	],
	"machine_max_speed_x": [
		"500"
	],
	"machine_max_speed_y": [
		"500"
	],
	"machine_max_speed_z": [
		"20"
	],
	"machine_min_extruding_rate": [
		"0"
	],
	"machine_min_travel_rate": [
		"0"
	],
	"max_layer_height": [
		"0.32"
	],
	"min_layer_height": [
		"0.08"
	],
	"printable_height": "250",
	"extruder_clearance_radius": "50",
	"extruder_clearance_height_to_rod": "30",
	"nozzle_diameter": [
		"0.4"
	],
	"printer_settings_id": "",
	"printer_variant": "0.4",
	"retraction_minimum_travel": [
		"2"
	],
	"retract_before_wipe": [
		"70%"
	],
	"retract_when_changing_layer": [
		"1"
	],
	"retraction_length": [
		"1"
	],
	"retract_length_toolchange": [
		"1"
	],
	"z_hop": [
		"0"
	],
	"retract_restart_extra": [
		"0"
	],
	"retract_restart_extra_toolchange": [
		"0"
	],
	"retraction_speed": [
		"35"
	],
	"deretraction_speed": [
		"35"
	],
	"single_extruder_multi_material": "1",
	"wipe": [
		"1"
	],
	"before_layer_change_gcode": ";BEFORE_LAYER_CHANGE\n\n;[layer_z]\n\nTIMELAPSE_TAKE_FRAME\n\nG92 E0.0",
	"layer_change_gcode": ";AFTER_LAYER_CHANGE\n;[layer_z]",
	"change_filament_gcode": "M600",
	"machine_end_gcode": "PRINT_END\nM84",
	"machine_pause_gcode": "PAUSE",
	"machine_start_gcode": "START_PRINT_PREPARE BED_TEMP=[bed_temperature_initial_layer_single]\nSTART_PURGE_WIPE TRAVEL_SPEED=[travel_speed]\nSTART_PRINT_COOL_PURGE\nSTART_PRINT_FINAL_HEAT BED_TEMP=[bed_temperature_initial_layer_single] NOZZLE_TEMP=[nozzle_temperature_initial_layer] TRAVEL_SPEED=[travel_speed]\nSTART_PRIME_LINES TRAVEL_SPEED=[travel_speed]\n; filament start gcode"
}