{
	"name": "LHS PC CF",
	"type": "filament",
	"filament_id": "LHF_pccf",
	"setting_id": "LHF_S_pccf",
	"from": "system",
	"instantiation": "true",
	"inherits": "fdm_filament_pla",
	"compatible_printers": [
		"LH Stinger 0.4 nozzle",
		"LH Stinger MMU 0.4 nozzle"
	],
	"additional_cooling_fan_speed": [
		"0"
	],
	"close_fan_the_first_x_layers": [
		"4"
	],
	"enable_pressure_advance": [
		"1"
	],
	"fan_cooling_layer_time": [
		"11"
	],
	"fan_max_speed": [
		"5"
	],
	"fan_min_speed": [
		"5"
	],
	"filament_cooling_final_speed": [
		"0"
	],
	"filament_cooling_initial_speed": [
		"0"
	],
	"filament_cooling_moves": [
		"0"
	],
	"filament_density": [
		"1.18"
	],
	"filament_flow_ratio": [
		"0.945"
	],
	"filament_loading_speed": [
		"0"
	],
	"filament_loading_speed_start": [
		"0"
	],
	"filament_max_volumetric_speed": [
		"35"
	],
	"filament_minimal_purge_on_wipe_tower": [
		"0"
	],
	"filament_multitool_ramming_flow": [
		"0"
	],
	"filament_multitool_ramming_volume": [
		"0"
	],
	"filament_notes": [
		"Extrusion Override set to a higher value\nAux disabled\nZ-Offset increased to 0.025 due to nozzle expansion at 300C"
	],
	"filament_retraction_length": [
		"0.4"
	],
	"filament_shrink": [
		"99.8%"
	],
	"filament_start_gcode": [
		"; filament start gcode\n; MPC_SET HEATER=extruder FILAMENT_DENSITY=1.36 FILAMENT_HEAT_CAPACITY=2.6\nMAX_FAN LINK_AUX=0"
	],
	"filament_type": [
		"PC"
	],
	"filament_unloading_speed": [
		"0"
	],
	"filament_unloading_speed_start": [
		"0"
	],
	"hot_plate_temp": [
		"105"
	],
	"hot_plate_temp_initial_layer": [
		"105"
	],
	"is_custom_defined": "0",
	"nozzle_temperature": [
		"300"
	],
	"nozzle_temperature_initial_layer": [
		"300"
	],
	"nozzle_temperature_range_high": [
		"300"
	],
	"nozzle_temperature_range_low": [
		"270"
	],
	"overhang_fan_speed": [
		"35"
	],
	"pressure_advance": [
		"0.025"
	],
	"slow_down_layer_time": [
		"7"
	],
	"slow_down_min_speed": [
		"12"
	],
	"filament_vendor": [
		"LH Stinger"
	],
	"temperature_vitrification": [
		"140"
	]
}