A print sliced for a nozzle that sits in the hotend rack (but is not
mounted) was blocked by the send dialog's mounted-nozzle diameter check,
even though the printer fetches the required nozzle itself (#14685).
Consolidate the three mounted-nozzle gates (_is_nozzle_data_valid,
is_nozzle_type_match, _is_same_nozzle_diameters) into a single
CheckErrorExtruderNozzleWithSlicing fed by s_get_slicing_extuder_nozzles,
which collects the plate's per-extruder nozzle requirements (hybrid
extruders contribute one entry per used sub-nozzle flow). The rack
extruder validates against its whole inventory (mounted + rack) with
guidance to calibrate the rack, refresh nozzle info, or re-slice, and
blocks when toolhead + rack are full (no free slot to stow a nozzle).
Other extruders keep the validity/flow/diameter checks against the
mounted nozzle.
Also add CheckErrorRackStatus, which holds Send while the printer is
still reading the rack hotend information, and judge material hardness
for the rack extruder per dispatch-mapped nozzle as a non-blocking
caution (mounted nozzles keep the blocking gate).
Nozzle rack data model and device-tab panel, multi-nozzle sync, per-nozzle filament blacklist, and print-dispatch nozzle mapping (DevNozzleMappingCtrl V0/V1).
* Don't assume 0.4mm nozzle; format as "unknown" if not defined.
* Skip nozzle diameter and hardness checks if nozzle info unknown.
---------
Co-authored-by: SoftFever <softfeverever@gmail.com>
SoftFever