Reduce the size of current and new JSONs by standardising them with 1 tab indentation instead of 4 spaces.
This effectively reduces the size by almost 20 MB.
| Current | New |
|---|---|
| 85.2 Mib | 67 Mib |
Used [JQ](https://jqlang.org/) `--tab` to automatically format every current JSON.
> [!NOTE]
> Some profiles had the arrays on the same line, but those created by Orca were in the standard format (each object below the previous one). In some cases, this increases the number of tabs due to the new lines, but the increase is negligible, and this way both the base profiles and those created by Orca maintain the same style.
* Added Elegoolink connection
* Set Elegoo CC default bed to btPTE
* Friendly output of some error codes of PrintHost
* feat: Add elegoo centauri carbon profile
* fix: Fix the issue where the bed type in the printer configuration does not match the bed temperature settings when multiple bed types are not supported.
* feat: Modify the elegoo process parameters to disable slowdown_for_curled_perimeters.
* feat: Update comment to clarify plate visibility for multi bed support, BBL printer, and selected bed type.
* fix: Optimize ElegooLink upload; The code is clearer than before.
* feat: Format the ElegooPrintHostSendDialog code.
* fix: Remove the unnecessary instantiation attribute in the Elegoo process.
* fix: Flatpak compilation failed
---------
Co-authored-by: anjis <anjis.zhou@elegoo.com>
* Initial add of N4Plus profile
Still some tuning to get it "right" but way better than nothing or just copying the Max profile.
* Fixing machine_start and manual filament change
Adding PRINT_START to the machine_start_gcode
Adding manual_filament_change override to True since this printer doesn't have automatic filament change.
* Adjusting accelerations and removing Z-Hop
Bumping accelerations to stock levels for all sizes and removing Z-Hop by default.
* Adding Z-Hop back in to be safe
Getting more stringing with Z-hop on but also rubbing prints during some moves.
* Removing print_start and lower accels a little
PRINT_START is automatically called on this printer so removing it from machine start gcode
Lowering accelerations a tiny bit. May bump it back up later but wanted a safer value.
