Remove unnecessary trailing spaces (#8752)

localization/i18n/zh_TW/OrcaSlicer_zh_TW.po

@@ -3586,7 +3586,7 @@ msgstr ""
 
 msgid ""
 "Alternate extra wall does't work well when ensure vertical shell thickness "
-"is set to All. "
+"is set to All."
 msgstr "當確保垂直外殼厚度設為『全部』時，交錯額外牆壁效果不佳。"
 
 msgid ""
@@ -8029,7 +8029,7 @@ msgid ""
 msgstr "預設「%1%」與新的列印參數設定檔不相容，並包含以下未儲存的變更："
 
 #, boost-format
-msgid "You have changed some settings of preset \"%1%\". "
+msgid "You have changed some settings of preset \"%1%\"."
 msgstr "已更改預設「%1%」的一些設定。"
 
 msgid ""
@@ -9856,7 +9856,7 @@ msgstr "懸挑上的額外周長"
 
 msgid ""
 "Create additional perimeter paths over steep overhangs and areas where "
-"bridges cannot be anchored. "
+"bridges cannot be anchored."
 msgstr "在陡峭的懸空和無法固定橋接的區域中增加額外的周長路徑。"
 
 msgid "Reverse on even"
@@ -11585,7 +11585,7 @@ msgstr "層和牆"
 msgid ""
 "Don't print gap fill with a length is smaller than the threshold specified "
 "(in mm). This setting applies to top, bottom and solid infill and, if using "
-"the classic perimeter generator, to wall gap fill. "
+"the classic perimeter generator, to wall gap fill."
 msgstr ""
 "若縫隙填充的長度小於設定的閾值（以 mm 計），則不列印該填充。此設定適用於頂"
 "部、底部和實心填充，以及使用經典牆產生器時的牆體縫隙填充。"
@@ -13028,7 +13028,7 @@ msgid ""
 "Using a non zero value is useful if the printer is set up to print without a "
 "prime line.\n"
 "Final number of loops is not taling into account whli arranging or "
-"validating objects distance. Increase loop number in such case. "
+"validating objects distance. Increase loop number in such case."
 msgstr ""
 "列印 Skirt 時的最小擠出線材長度（單位：毫米）。設為 0 表示停用此功能。若列印"
 "設備設定為不使用沖洗線材，建議設定為非零值。注意，排列或驗證物件距離時，最終"