fixed an issue that some translations are not used

localization/i18n/zh_CN/OrcaSlicer_zh_CN.po

@@ -6,7 +6,7 @@ msgid ""
 msgstr ""
 "Project-Id-Version: Slic3rPE\n"
 "Report-Msgid-Bugs-To: \n"
-"POT-Creation-Date: 2026-03-20 23:26+0800\n"
+"POT-Creation-Date: 2026-03-20 23:39+0800\n"
 "PO-Revision-Date: 2026-02-28 00:59\n"
 "Last-Translator: Handle <mail@bysb.net>\n"
 "Language-Team: \n"
@@ -4086,7 +4086,6 @@ msgstr ""
 "seam_slope_start_height需要小于layer_height。\n"
 "重置为0。"
 
-#, fuzzy, c-format, boost-format
 msgid ""
 "Lock depth should smaller than skin depth.\n"
 "Reset to 50% of skin depth."
@@ -13743,7 +13742,6 @@ msgstr "首层的线宽。若以百分比表示（例如120%），它将基于
 msgid "First layer height"
 msgstr "首层层高"
 
-#, fuzzy
 msgid ""
 "Height of the first layer. Making the first layer height thicker can improve "
 "build plate adhesion."
@@ -14582,7 +14580,6 @@ msgstr "顶面"
 msgid "Topmost surface"
 msgstr "最顶面"
 
-#, fuzzy
 msgid "All solid layers"
 msgstr "所有实心层"
 
@@ -15057,7 +15054,6 @@ msgstr ""
 "模型底部的孔洞在被圆锥形材料填充前所允许的最大面积。值为0将填充模型底部的所有"
 "孔洞。"
 
-#, fuzzy
 msgid "Detect overhang walls"
 msgstr "识别悬垂外墙"
 
@@ -15668,7 +15664,6 @@ msgstr ""
 msgid "Minimum sparse infill threshold"
 msgstr "稀疏填充最小阈值"
 
-#, fuzzy
 msgid ""
 "Sparse infill areas smaller than this threshold value are replaced by "
 "internal solid infill."
@@ -16376,11 +16371,9 @@ msgstr ""
 msgid "Nozzle temperature for layers after the initial one."
 msgstr "除首层外的其它层的喷嘴温度"
 
-#, fuzzy
 msgid "Detect thin walls"
 msgstr "检查薄壁"
 
-#, fuzzy
 msgid ""
 "Detect thin walls which can't contain two line widths, and use single line "
 "to print. Maybe not printed very well, because it's not a closed loop."
@@ -16946,7 +16939,6 @@ msgstr ""
 "用于替换模型上的细小特征（根据最小特征尺寸决定）的墙线宽。如果最小墙宽度小于"
 "最小特征宽度，则墙将变得和特征本身一样厚。本设置以喷嘴直径的百分比表示。"
 
-#, fuzzy
 msgid "Detect narrow internal solid infills"
 msgstr "识别狭窄的内部实心填充"